Step 4 – Attach Headboard and FootboardĪt each end of the headboard you'll find two bolt holes. Fit an end cap over each end of the frame to keep dust ruffles and bedding from snagging on these end pieces. When you've finished, each end of the center bar should be attached solidly to the middle hole of each side rail. Do the same with the opposite end of the center bar, and use your wrenches to tighten the nuts on the appropriate bolts. Slide on a washer, then screw on the nut. Align the hole at each end of the center bar with the hole in the appropriate side bar, and insert into one of these holes the bolt that will hold the side rail and the center bar end together. On each end of the center bar you'll find a hole of similar size. Halfway down each side rail you'll find a hole. Then, into the slots you've chosen, lock the side arm ends. Locate the slots into which you will be inserting the arms, and determine by measuring which of these slots you should use for your box springs to fit properly on the frame. Pull these arms out until they are each positioned 90 degrees from the side rails. The arms of the top and bottom rails will most likely be folded into one piece for the top rail and another for the bottom rail. You may have to tap them slightly with a hammer to snap them into place. If this is the first time you've assembled this frame, you will also need to attach its casters by sliding the caster ends into the legs. Into each of these rails insert the legs. Then, lay out the two side rails in the position they will be when the bed is assembled. Decide on which wall you will want your headboard located. Your bed will be much more difficult to move once it is assembled, so now will be the best time to arrange its position.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |